My Brushless Tnx with Mamba Monster Max

[enty]

hi,
here is my Tnx with MMM and 2200Kv Motor. I fixed it in the second Gear and drive with 2x 2S Vtec Lipos and i tried it on 2x3S Lipos
Someone know the gear ratio from the tnx? is 7,09:1(only the gearbox and diff gear ratio) right ?
here some Pics:





here is a small video from the first test
http://www.youtube.com/watch?v=Tjw_3b46ZMU

greets enty

[McFig]

That is impressive power. Very nice.

Not sure on the ratio.

[sonicm21]

what is the power like compared to the 5.2 engine?? and how long do you get out of the batterys??

[enty]

hi,
i think the brushless have more power then the nitro engine and he is better to drive. with 4S the speed is at 58km/h, with 6S i dont´t know how much the speed is, maybe 80km/h. the 4s lipos holds 20-30min and wheelies on demand.

greets enty

[enty]

i have a new video from my

http://www.youtube.com/watch?v=-zPZyfD5aVE

[coolink13]

Hey Nice Job with the TNX!!! Runs Well. My Question is? How Did you modify the Revo slipper set up? I'm interested in doing the same. I'm in the middle of my own TNX 3.0 Brushless conversion. Have successfully converted A Jato/REVO 3.3/ LST Aftershock so far. I think the TNX may be the favorite of the Electric Bunch.

[enty]

thanks
i hope i see some pics when your bl-tnx is ready

i hope you understand my bad english....
i put the original transmission shaft in the turning lathe and remove the hexagon because i need a 5mm shaft. Then i put a sleeve to the front at the end of the thread and drill a 3mm hole. i have only these 2pics from the slipper mod.
http://img34.imageshack.us/img34/6732/dsc03825z.jpg
http://img29.imageshack.us/img29/3372/dsc038261m.jpg

[coolink13]

Thanks for quick response to my slipper question. I will definitely post some pics when it done and building process. Thanks for the pics. Your English is fine. I saw what you did with the shaft nice job. But I think I understand the sleeve idea. But it looks like you the shaft has a hole in it to accommodate f=or the pin to hold the revo parts correct? I may try to hex the revo slipper to fit. Its soft metal. I will let you know.

[Ryborg001]

how come you have a revo slipper set up?

[enty]

because the slipper is more durable and the spur gear is plastic. i have tried it with the orig. steel spur gear but it was very loud and with the plastic its very quietly